Connecting to a Power Source
■You can charge the rechargeable battery
●Using the
: Insert the AC adapter into the USB connector.
When the AC adapter is inserted, it can be used as an AC charger.
■Charging LED of the AC Adapter
| Charging LED | |
|
| |
Being Charged | Red LED is on | |
|
| |
Charging is complete | Green LED is on | |
|
| |
Charging error | Red LED is off or blinking | |
|
| |
Being discharged | Orange coloured LED is on | |
(Using the AC adapter) | ||
| ||
|
|
●Using the
: Remove the AC adapter from the USB connector. You can transmit data with a PC (p.67) or charge the battery.
CAUTION
In the following cases, the battery may not be charged.
●When using the USB cable that was not supplied with this camera : Use the supplied USB cable.
●When using a USB hub : Connect the camera to the PC directly.
●When other USB devices are connected to the PC : Disconnect the other USB devices.
●When the USB is connected to the USB port located on the front of the computer : Use the USB located on the back of the computer.
●If the USB port of the PC doesn't meet the Power output standard (5V, 500mA), the camera may not be charged.
CAUTION
●Before inserting any cables or connecting the AC adapter, check the directions and do not use force which might damage the cable or camera.
●If the charging LED of the AC Charger does not turn on or blink after inserting the rechargeable battery, please check whether the battery is inserted correctly.
●If you charge the battery with the camera power on, the battery can't charge fully. Turn the camera off while charging the battery.
●If you insert the fully discharged battery to charge it, do not turn on the camera at the same time. The camera may not be turned on because of the low battery capacity. Charge the battery for more than 10 minutes before using the camera.
●Do not use the flash frequently or take a movie clip with a fully discharged battery that has only been charged for a short time.
