O P E R AT I O N
Storing Channels in Memory (Automatic Method)
1
First, select the correct signal source (ANT, STD, HRC, IRC). See steps 1~2 on previous page.
Press the Menu button. Move the joystick down to select “CHANNEL”, then press the joystick to enter.
2
Move the joystick down to select “Auto Program”, then press the joystick to enter.
3
The TV will begin memorizing all of the available channels.
After all the available channels are stored, the Auto program menu reap- pears. Press the Menu button to exit.
▼ The TV automatically cycles through all of the available chan- nels and stores them in memory. This takes about one to two min- utes.
Move the joystick to the right at any time to interrupt the memo- rization process and return to the Setup menu.
Note: Channel auto program does not function when the V-chip is active.
Adding and Erasing Channels (Manual Method)
1
Use the number buttons to directly select the channel that will be added or erased.
2
Press the Add/Erase button:
Repeatedly pressing this button will alternate between “Channel added” and “Channel erased.”
Press the Menu button to exit.
You can view any channel (including an erased channel) by using the number buttons on the remote control.
CHAPTER THREE: TV OPERATION 3.9
