Samsung HPN4239 manual How to Set up Your PC Software Windows only

How to Set up Your PC Software (Windows only)

The Windows display-settings for a typical computer are shown below. However, the actual screens on your PC will probably be different, depending upon your particular version of Windows and your particular video card. But even if your actual screens look different, the same, basic set-up information will apply in almost all cases. (If not, contact your computer manufacturer or Samsung Dealer.)

On the windows screen, select in the following sequence : Start ➝ Settings ➝ Control Panel.

When the control panel screen appears, click on “Display” and a display dialog-box will appear.

Select the “Settings” tab in the display dialog- box.

The two key variables that apply to the PDP-PC interface are “resolution” and “colors”.

The correct settings for these two variables are:

• Size (sometimes called “resolution”) :640 x 480 pixels.

• Color: “24-bit” color (might also be expre- ssed as “16 million colors”)Shown at left is a typical screen for “Display” dialog box.

If a vertical-frequency option exists on your display settings dialog box, the correct value is “60” or “60 Hz”. Otherwise, just click “OK” and exit the dialog box.

Continued...

Notes:

Both screen position and size will vary, depending on the type of PC monitor and its resolution. The table below shows all of the display modes that are supported:

Video Signal		Resolution		Vertical	Horizontal	Vertical	Horizontal
		(Dot X Line)		Frequency(Hz)	Frequency(KHz)	Polarity	Polarity
			640 X 350	70.086	31.469	N	P
			720 X 400	70.087	31.469	P	N
	VGA			59.940	31.469
			640 X 480	72.809	37.861	N	N
				75.000	37.500
				56.250	35.156	N/P	N/P
	SVGA		800 X 600	60.317	37.897	P	P
IBM PC / AT				72.188	48.077	P	P
Compatible				75.000	46.875	P	P
				60	29.838
	WVGA		848 X 480	72	36.072	nVidia chipset
				75	37.650
				60.004	48.363	N	N
	XGA		1024 X 768	70.069	56.476	N	N
				75.029	60.023	P	P
	* SXGA		* 1280x1024	60.020	63.981	P	P

•The interlace mode is not supported.

•The PDP operates abnormally if a non-standard video format is selected.

•This sheet conforms to IBM/VESA regulations and is prepared on the basis of Analog Input.

•* mode is not supported during the input of DVI.

Notes:

•When this PDP is used as a PC display, 32-bit color is supported.

•Depending on the manufacturer, your PC display screen might appear different. (and depending on your particular version of Windows).

Check your PC instruction book for information about connecting your PC to a PDP.

•If a vertical and horizontal frequency-select mode exists, select 60Hz (vertical) and 31.5kHZ (horizontal).

•In some cases, abnormal signals (such as stripes) might appear on the screen when the PC power is turned off (or if the PC is disconnected). If so, press the TV/VIDEO button on the remote control or SOURCE button on the front panel to enter the VIDEO mode. Also, make sure that the PC is connected.

•Connect only a PC monitor to the monitor output port while viewing the PC screen. (Otherwise, random signals might appear).

70 71