Samsung HPN4239 manual Connecting Speakers, How to Connect

Cable with a Cable Box that Descrambles Some (But Not All) Channels

To complete this connection you will need a two-way splitter, an RF (A/B) switch, and four coaxial cables (which you can buy from your Samsung dealer or any electronics store).

Find and disconnect the cable that is con-

1 nected to the ANTENNA IN terminal of your cable box.

This terminal might be labeled "ANT IN", "VHF IN" or simply, "IN". Connect this cable to a two-way splitter.

Connect a coaxial cable between an OUT-

2 PUT terminal of the splitter and the IN termi- nal of the cable box.

Connect a coaxial cable between the

3 ANTENNA OUT terminal of the cable box and the B-IN terminal of the A/B switch.

Connect a coaxial cable between the

4 ANTENNA OUT terminal of the cable box and the B-IN terminal of the A/B switch.

Connect the last coaxial cable between the

5 OUT terminal of the RF (A/B) switch and the VHF/UHF terminal on the PDP.

After you've made this connection, set the A/B switch to the "A" position for normal viewing.

Set the A/B switch to the "B" position to view scrambled channels. (When you set the A/B switch to "B", you will need to tune your Set-Top Box to the cable box's output channel, which is usually channel 3 or 4.)

22

Connecting Speakers

External speakers are sold seperately. Check with your dealer.

SpeakerrCable

Powered Subwoofer

(Option)

✱ External speakers MUST have a power handling capability of 10 watts minimum (impedance 8 ohm).

If using a subwoofer with this unit, make sure it is powered(active).

How to Connect

Connect the speaker audio cable to the external speaker output jack on the PDP matching the “+” and “-” ends of the cable with the diagram on the PDP.

Connecting PDP and Speakers

1 Fix the bracket onto the guide pole located on the rear of speaker and fasten the screws.

2 After removing the three screws on the PDP, clamp the speaker and the PDP together and fasten the screws.

Guide pole

Guide pole

23