Samsung ML-4050ND Configuring the wireless network parameters, Configuring basic network settings

5Close the control board cover by aligning the groove on it with the notch on the printer and sliding it.

6Reinstall the duplex-slot cover or the duplex unit.

7Reconnect the power cord and printer cable (if necessary), and turn the printer on.

Configuring the wireless network parameters

After installing the wireless network card, you must configure the appropriate network parameters to use your printer in a wireless network. To do this, you can use both control panel and SyncThru Web Service, an embedded web site of your printer. This section gives you basic information on 802.11b/g network parameters which can be configured from the control panel. See the supplied Network Printer User’s Guide.

Configuring basic network settings

You can configure basic wireless settings, such as SSID, Operation Mode, and channels. You can retrieve basic settings by selecting a wireless network or manually configure them as you need.

1Press Menu until Network appears on the bottom line of the display and press OK.

2Press the Scroll buttons until Wireless appears and press OK.

3Press OK when WLAN Basic appears.

4Press the Scroll buttons to select the setup method you want and press OK.

•Search List: The wireless network interface card on your printer searches for wireless networks in the area and shows the results.

•Custom: You can configure the wireless settings according to your needs.

5If you selected Search List, press the Scroll buttons to select a network and press OK.

If you selected Custom, set each network options:

•Edit SSID: Enter the SSID, the name that identifies a wireless network. SSID is case-sensitive so you need to enter it.

• Operation Mode: Select the type of wireless connections.

In Ad-Hocmode, wireless cards communicate directly each other.

In Infrastructure mode, network cards communicate with each other through an access point, which allows both wireless and cabled cards to send files to the printer. If you select Auto, the printer selects the operation mode automatically, according to the network cable’s connection each time it boots up.

Note

In Ad-Hocmode, even if the network cable is connected, your printer will use the wireless interface.

•Channel: This option is available only in the Ad-Hoc mode. In most cases, you will not need to change this setting. The printer will scan all available channels for the specified network and will adapt its channel to the one detected.

6When you have finished, press Stop button to return to Standby mode.

Selecting the authentication type

Authentication is a process of identifying the legitimacy of an user to access a network. You can select whether or not authentication is used.

1Press Menu until Network appears on the bottom line of the display and press OK.

2Press the Scroll buttons until Wireless appears and press OK.

3Press the Scroll buttons until WLAN Security appears and press OK.

4Press the Scroll buttons until Static WEP appears and press OK.

5Press the Scroll buttons until Authentication appears and press OK.

6Press the Scroll buttons to select the type you want.

•Open System: Authentication is not used.

•Shared Key: Authentication is used.

7Press OK to save your selection.

8Press Stop button to return to Standby mode.

10.4 <Installing accessories>