Samsung RF28HMEDBSR/ML manual Using the Control Panel, Alarm/Filter Reset 3sec, Energy Saver

Operating your French Door Refrigerator

USING THE CONTROL PANEL

( 2 ) Alarm/Filter Reset (3sec)

1

2

3

8

7

4

5

10

6

9

The Alarm button serves two purposes: -- To turn the door open alarm on and off -- To reset the water filter life indicator.

1) Door Alarm Function

If the door alarm is set to On, an alarm beeps if any refrigerator door is left open for more than three minutes. The beeping stops when you close the door. The door alarm function is pre-set to On in the factory. You can turn it off by pressing and then releasing the Alarm button. You can turn it back on in the same fashion. The icon lights up when the function is on.

When the Door Alarm function is on and the

( 1 ) Freezer/Power Freeze (3sec)

The Freezer button serves two purposes: -- To set the Freezer to your desired

temperature.

-- To turn the Power Freeze function on and off.

1) To set the Freezer temperature,

touch the Freezer button. You can set the temperature between -15 °C (5 °F) and -23 °C (-8 °F).

2) Power Freeze function

Touch and hold this button for 3 seconds to decrease the time needed to freeze products in the Freezer.

It can be helpful if you need to quickly freeze easily spoiled items or if the temperature in the freezer has warmed dramatically (For example, if the door was left open).

When you use this function, the energy consumption of the refrigerator will increase. Remember to turn it off when you don’t need it and return the freezer to your original temperature setting.

This icon will light up when you activate the Power Freeze function. Power Freeze function generates cool air for 72 hours continuously and it makes the inside of the refrigerator cool faster. When you have enough, just press and hold the Freeze (Hold 3 sec for Power Freeze) button again for 3 seconds to cancel the Power Freeze function.

alarm sound is triggered, the Door Alarm Icon will blink while the alarm sounds.

2) Water Filter Life Indicator Function

After you replace the water filter, touch and hold this button for 3 seconds to reset the water filter life indicator. When you reset the water filter life indicator, the Filter icon on the panel turns Off. The Filter icon will turn red to let you know it is time to change the water filter after six months (about 300 gallons). Some areas have large amounts of lime in their water, which causes the water filter to clog more quickly. If this is the case in your area, you will have to change the filter more frequently than every six months.

( 3 ) Energy Saver

Touching this button turns Energy Saver mode on and off. When you turn Energy Saver on, the Energy Saver icon lights. Turn Energy Saver off and the icon goes off. The Energy Saver function’s factory setting is “ON”. If condensation or water drops appear on the doors, turn the Energy Saver mode off.

English - 26

DA68-02952D-02.indb 26 2016. 12. 16.

�� 7:50