( 2 )

( 3 )

3.Insert the new filter into the filter case ( 4 ).

( 4 )

4.Push the filter, and then turn it clockwise until it locks.

If you have trouble inserting the water filter because of high water pressure, shut off the water supply valve.

Removing any residual matter inside the water supply line after installing the water filter.

1.Turn ON the main water supply and supply water from water supply line.

2.Run water through the dispenser until the water runs clear (approx. 6 to 7 minutes). This will clean the water supply system and remove air from the lines.

3.Additional flushing may be required in some households.

4.Open the Refrigerator

door and make sure there are no water leaks coming from the water filter.

Be sure to flush the dispenser thoroughly, otherwise water may drip from the dispenser.

This means that there is still air in the line.

g poeratin

The locked symbol should be lined up with the indicator line.

5.Touch and hold the “Alarm / hold 3 sec for

Filter Reset” button ( (Filter Reset) ) for about

3 seconds to reset the water filter indicator. The indicator’s red light will turn off.

6.If you turned off the water supply, turn it back on.

For a replacement water filter, visit your local home Improvement center or visit Samsung’s parts distributor on line at:

http://www.samsungparts.com

Be sure the replacement water filter has the SAMSUNG logo on the box and on the water filter.

Reverse Osmosis Water Supply

IMPORTANT : The pressure of the water supply coming out of a reverse osmosis system going to the water inlet valve of the refrigerator needs to be between 35 and 120 psi (241 and 827 kPa).

If a reverse osmosis water filtration system is connected to your cold water supply, the water pressure to the reverse osmosis system needs to be a minimum of 40 to 60 psi (276 to 414 kPa.)

If the water pressure to the reverse osmosis system is less than 40 to 60 psi (276 to 414 kPa):

Check if the sediment filter in the reverse osmosis system is blocked. Replace the filter if necessary.

Allow the storage tank on the reverse osmosis system to refill after heavy usage.

If your refrigerator has a water filter, it may further reduce the water pressure when used

in conjunction with a reverse osmosis system. Remove the water filter.

If you have questions about your water pressure, call a licensed, qualified plumber.

English - 29

DA68-02952D-02.indb 29

2016. 12. 16.

�� 7:50

Page 29
Image 29
Samsung RF28HMEDBSR/ML manual Reverse Osmosis Water Supply, Touch and hold the Alarm / hold 3 sec for