When moving your refrigerator
To prevent floor damage, be sure the front CAUTION adjusting legs are in the up position (above
the floor).
Refer to ‘Adjusting the doors’ on page 22.
Control Lever | |
|
FLOORING
For proper installation, you must place this refrigerator on a level, hard surface that is the same height as the rest of the floor. This surface should be strong enough to support a fully loaded refrigerator. To protect the finish of the flooring, cut a large section of the cardboard carton and place it under the refrigerator where you are working. When moving a refrigerator, you need to pull and push it straight forwards or back. Do not wiggle it from side to side.
REMOVING THE REFRIGERATOR DOORS
For some installations, you need to remove the fridge doors and freezer drawer so you can move the refrigerator to its final location. Do not remove the doors/drawers if you don’t need to. If you do not need to remove the refrigerator doors or drawers, go to ‘Adjusting the Level’ on page 22.
If you need to remove the doors and drawers. continue below. Before removing the doors or drawers, make sure you read the following warnings:
Disconnect power to the refrigerator before WARNING removing the door or drawer.
•Be careful not to drop, damage, or scratch the doors/drawer while removing them.
•Be careful not to injure yourself while removing the doors/drawer.
•Reattach the doors/drawer properly to avoid:
-Moisture from air leakage.
-Uneven door alignment.
-Wasting energy due to improper door seal.
English - 18
2016. 12. 16. |
��
7:50
