BEFORE USING ICEMAKER

• Remove

-- Hold the handle as shown in Figure1. -- Slightly pull up the bottom part.

-- Take out the ice bucket slowly.

Ice Chute

Figure 1

• Install

-- Assemble the icemaker in the reverse order of disassembly.

-- Push the bucket in firmly until you hear a clicking sound.

-- If the bucket does not fit into its place, turn the gear handle on its back by 90 degrees and reinstall it again as shown in Figure 2.

Figure 2

• Before calling service

-- Any sounds you hear when the ice maker dumps ice into the bucket are part of normal operation.

-- If you don’t dispense ice for a long period of time, the ice may form clumps in the ice bucket. If ice clumps form, remove the remaining ice and empty the bucket.

-- When ice does not come out, check for ice stuck in the chute and remove it.

•When Ice Off blinks on the display

CAUTION panel, reinsert the bucket and/or make sure it’s installed properly.

•When the door is open, the Ice and water dispenser do not work.

•If you close the door hard, it may cause water spilling over the ice maker.

•To prevent dropping the ice bucket, use both hands when removing it.

•To prevent injury, be sure to clean up any ice or

water that may have dropped on the floor.

•Do not let the children hang on the ice dispenser or on the bucket.

They may get hurt.

•Be sure not to put your hand or any object into the ice chute.

It may cause personal injury or damage mechanical parts.

English - 14

DA68-02500B-13.indb 14

13. 12. 4. �� 7:12