Removing residual matter inside the water supply line after installing filter.

1.Turn ON the main water supply.

2.Press the Water button and push the Dispenser Lever.

3.Flush 1 gallons of water through the filter before use. (Flush approximately 6 minutes.) This will clean the water supply system and remove air from the lines.

4.Additional flushing may be required in some households.

5.Open the refrigerator door and make sure there are no water leaks coming from the water filter.

Check the amount of water supplied to the ice tray.

1.Lift up the icemaker cover and gently pull it out.

2.When you press the Test button for 3 seconds, the ice cube container is filled with water from the water supply tap.

Check to make sure the amount of water is correct (see the illustration below).

If the water level is too low, the ice cubes will be small.

This is a water pressure problem from within the main water pipes, not the refrigerator.

up 01setting

Ice Water

A newly installed water filter cartridge may cause water to briefly spurt from the water dispenser.

This is due to air getting into the line. It should pose no problem to operation.

Check the water level

1

2

Ice maker

Test button

 

It will take a few minutes to reach the

CAUTION amount of water you want.

Do not press the test button continuously when

the tray is filled with ice or water.

Water may overflow or ice jamming may occur.

When the bucket is not installed, the ice maker does not work.

When “Ice maker will not work when the ice bucket is not installed” message appears on the display panel, reinsert the bucket and/or make sure it’s installed properly.

English - 15

DA68-02500B-13.indb 15

13. 12. 4.

�� 7:12

Page 15
Image 15
Samsung RSG309AARS/XAA manual Check the amount of water supplied to the ice tray