Troubleshooting
6.1.5 Light Image
• Description
Digital Printer
Digital Printer
Digital Printer
Digital Printer
Digital Printer
The printed image is light, with no ghost.
| Check and Cause |
| Solution |
|
| ||
1. Toner Save mode enabled | 1. Ensure the Toner Save mode is off. Check | ||
|
|
| set and driver settings. |
2. | Develop roller is contaminated or the | 2. | Replace the toner cartridge and try to print |
| toner cartridge is almost empty. |
| out again. |
3. Ambient temperature is below than 10°C. | 3. | Wait 30 minutes after printer is powered on | |
|
|
| before you start printing. |
4. | Bad contact caused by dirty terminals on | 4. | Clean the cartridge and set contacts. |
| the toner cartridge or set. |
| Generally clean dirt from inside the set. |
5. | Abnormal output from the HVPS. | 5. Replace the HVPS if the problems are not | |
| (Run EDC mode – see sections 6.1.2 |
| solved by the above four instructions. |
| and 6.1.3) |
|
|
|
|
|
|
6.1.6 Dark Image or a Black
• Description
Digital Printer
Digital Printer
Digital Printer
Digital Printer
Digital Printer
The printed image is dark.
| Check and Cause |
| Solution |
1. | No charge voltage in the engine board. | 1. | Check the state of the connector which |
|
|
| connects the engine board and HVPS. |
2. | Charge voltage fault due to bad contact | 2. | Clean the high voltage charge terminals. |
| between toner cartridge and set contacts. | Note if 1 and 2 do not resolve the problem | |
|
|
| and the problem persists replace the |
|
|
| HVPS. |
3. VD0 signal of the Main PBA is Low state.
3. Replace the LSU Unit or Main PBA.
| Service Manual | |
Samsung Electronics |
| |
|
|
