Loading paper in the tray
Load the print media you use for the majority of your print jobs in the tray. The tray can hold a maximum of 100 sheets of 75 g/m2 (20 lb bond) plain paper.
1Press the tray open button, then the tray pops out. Pull the tray completely out.
Note
When the tray does not close properly, pull the tray half way out and try again.
2Place paper with the side you want to print facing down.
3Align the tray with the slot, and slide it into the machine.
4After loading paper, set the paper type and size for the tray. See Software section for
Note
• You can load previously printed paper. The printed side should be facing up with an uncurled edge at the rear. If you experience problems with paper feed, turn the paper around. Note that print quality is not guaranteed.
Changing the paper size in the tray
To load different sizes of paper, such as
1 paper length guide
2 paper width guide
1Adjust the paper length guide to the desired paper length. It is preset to Letter or A4 size depending on the country. To load another size, hold the lever and move the length guide to the corresponding position.
Note
• The tray is preset to Letter or A4 size, depending on your country.
•For example, if you want to change the size to Letter, hold the lever at the back of the tray, and rotate the lever clockwise.
4.5 <Loading originals and print media>
