Netcam(W)_SNC-L200(W)

Netcam(W)_SNC-L200(W)

Title of Each Component

Passive Infrared (PIR)Sensor

Detects and records motion of a human or an animal by using an infrared ray.

-Selects perform or cancel by using the PIR Sensor Button of Smart/Multi Viewer.

-Flash can be turned on in link with the PIR Sensor.

Range of detection left and right

Range of detection up and down

Distance and Range

Distance of Detection : Up to 3m

Range of detection (up and down) : Around 85°

Range of detection (left and right) : Around 40°

The left and right range of detection may change if motion is fast.

Avoid exposing this product to direct sunlight, air conditioner or heater, high or cold temperature, humidity, oil, smoke and glass when installing the product.

Warning The Sensor may malfunction.

Flash

You can monitor the environment even in a dark room by using flash.

-Turns on the flash by using the Flash button of the Smart/Multi Viewer.

-Flash can be turned on in link with the PIR Sensor.

-Flash is turned on for 5 seconds and off for 30 seconds.

Even i f you click the Flash Button in 30 seconds, flash is not turned on.

-Flash is also turned on for 5 seconds and off for 30 seconds when using the PIR Sensor.

Range of light emitting left and right

Range of light emitting up and down

Distance and Range

Distance of Light Emitting : Up to 3m

Range of detection (up and down) : Around 67°

Range of detection (left and right) : Around 67°

Privacy

Turns the lens out of the performance range to prevent shooting for privacy.Press the Privacy Button.

-Every time you press the button, [the lens moves out of

the performance range ‘Privacy Mode’ is displayed

and video is not transmitted restore to the previous state ] process is repeated.

Reset

When the product is not in normal conditions, you can set the values to factory default.

Press the Reset Button on the back for more than 5 seconds.

- Refer to the title of each component for the location of the Reset Button (page 12).

-All the values are restored to factory default settings, and the system is rebooted. Use the product after some 2 minutes.

Do not use this function unless necessary.

Stored values such as the network settings, registered users, the title of the Netcam(W), firmware upgrades are all switched to

Warning factory default settings.

14

15