Setting the Network
Manually Setting the Network 
When connecting the Netcam(W) by using the Manual Set, you must enter the IP and the Subnet Mask since they are allocated automatically.
1 Press the Manual Set Button on the bottom of the SNC Installer screen.2 Enter a value for each item.Click
Note | - If you set the IP Type to DHCP, you must reset the “UPnP” settings again when | |
power is turned off and later on. It is recommended to set the IP Type to Static. | ||
| ||
| - If you set the IP Type to DHCP, there may be access control when using the | |
| external Internet. It is recommended to set the IP Type to Static. | |
| - When using wireless connection of the NetcamW | |
| (Choosing the ‘Wireless Enable’), you cannot set the IP Type to DHCP. | |
|
|
The following screen appears for
about 2 minutes.
When the local network setup is completed, the Internet Set (UPnP) setup window appears as follows.
-Click the “Yes” Button to set up the connection to the Internet
(refer to pages 38 to 40).
-Click the “No” Button to not set up the connection to the Internet.
3 Apply the settings to the Netcam(W), and click the Set Button to store the settings in the Save Configuration Option.
- Click the Cancel Button to cancel
the settings.
Click
4 Click the ‘Yes ’Button.30 | 31 |