Turning Your Phone ON and OFF

Turning Your Phone ON

Press for a few seconds. The phone will display “Powering On” until it locates a signal, then it will automatically enter Standby mode — the phone’s idle state. At this point, you’re ready to begin making and receiving calls.

If your phone is unable to find a signal after 15 minutes of searching, a Power Save feature is automatically activated. When a signal is found, your phone automatically returns to Standby mode.

In Power Save mode, your phone searches for a signal periodically without your intervention. You can also initiate a search for

PCS Service by pressing any key (when your phone is turned ON).

Tip: The Power Save feature helps to conserve your battery power when you are in an area where there is no signal.

Turning Your Phone OFF

Press for a few seconds until you see the powering down animation on the display screen.

Your screen remains blank while your phone is off (unless the battery is charging).

Adjusting the Brightness & Contrast

1.To adjust the brightness from the PDA menu, tap the brightness icon

located in the upper left corner of the alpha Graffiti writing area.

2.Use the slider to adjust the desired brightness level. Tap Done to save and exit.

22

Page 26
Image 26
Samsung SPH-I330 manual Turning Your Phone on and OFF, Turning Your Phone OFF, Adjusting the Brightness & Contrast