installation and external connection
BYPASS DIODE CONNECTION
If you connected an inductor (door locks or alarm device) to the output relay, there should occur a voltage surge while the inductor is turning on and off. If you do not connect a reverse diode to the relay, the surge voltage will cause damage to the electric circuit of the controller. To reduce this surge, it is recommended to connect a reverse diode between the devices.
X | Y | Z |
[ | \ | ] |
^ | _ | ` |
lzj | W | lu{ |
i |
|
|
|
| zzhTzYWWW |
I/O CONNECTION
DC+
DC-
Lock/Alarm
Cathode Anode
1N4004 ~ 1N4007 or equiv.
Input Connection
X Y Z
[ \ ]
^ _ `
lzj W lu{
i
zzhTzYWWW
Door Contact Sensor
Exit Button
Door Contact Sensor: Green with red stripes, GND
Exit Button: Orange line, GND
Black- |
|
Red+ | DC + 12V |
Power Supply
PUSH
1.Connect the DC 12V(+) of the power supply unit to the red line.
2.Connect the
- Exit Button Connection
1.Connect one line of the Exit button to the orange line.
2.Connect the other line of the Exit button to GND.
- Door Contact Sensor Connection
1.Connect one line of the door contact sensor to the yellow with red stripes.
2.Connect the other line of the door contact sensor to GND.
-Auxiliary Input Device Connection (AUX 1 (green), AUX 2 (green with white stripes), AUX 3 (green with red stripes)
1.Connect one line of the external input device to AUX 1, AUX 2, or AUX 3.
2.Connect the other line of the external input device to
