Samsung SSA-S2000W user manual To Specify the Output Time if the Card is not Authenticated

I/O time setup

TO SPECIFY THE OUTPUT TIME IF THE CARD IS NOT AUTHENTICATED

You can specify the output time if an unregistered card or PIN number fails in getting authenticated.

1.Present the Master Card to the device.

2.	Press Button 2 twice and press ENT .
3.	Refer to the output port table on page 29 and specify a desired output mode.

tˆš›Œ™Gjˆ™‹

X Y Z

\ ]

`

lzj W lu{

	• If you want the alarm relay alone to operate in normal and Secure modes for				iŒ““		zzhTzYWWW
	an unauthenticated card, select the < 5	2 > buttons and press		ENT
	.
4.	Enter the two-digit door relay output time and press		ENT .		X	Y	Z
					[	\	]
5.	Enter the two-digit alarm relay output time and press		ENT .		^	_	`
					lzj	W	lu{
6.	Enter the two-digit TTL output time and press	ENT .			iŒ““
							zzhTzYWWW

•You can specify a two-digit time from 00 to 99 seconds.

By default, only the alarm relay operates for “02” seconds in normal and Secure modes.

M Other output ports that are not specified for the output mode will not be activated. For instance, if you set the output mode to [5][2] and assign the operation time for each output device by following the steps 4, 5, and 6 above, only the alarm relay will operate.

TO SPECIFY THE DURESS TTL OUTPUT

If you enter the Duress code and present a registered card, the TTL output operates. Specify the TTL operation time for this purpose. (For the Duress code, refer to Duress Alarm on page 24.)

1.Present the Master Card to the device.

2. Press Button 3 and Button 0 in sequence and press ENT .

3.Specify the two-digit TTL output time (unit: second) and press ENT .

•The default is set to “03” second.

You can specify a time from 00 to 99 seconds.

	X	Y	Z
		\	]
			`
tˆš›Œ™Gjˆ™‹	lzj	W	lu{
	iŒ““
			zzhTzYWWW
	X	Y	Z
		\	]
	^	_	`
	lzj	W	lu{
	iŒ““
			zzhTzYWWW

30_ I/O Time Setup