Sanyo CLT-D5880, CLT-D5883, CLT-D5882 Connect the base unit and charge the handset

UP800DH(CLT-D5880) OM 1/24/06 3:38 PM Page 7

GETTING STARTED

C. Connect the base unit and charge the handset

1 Connect the AC adapter to the DC IN 9V jack and to a standard 120V AC wall outlet.

2 Set the base on a desk or tabletop.

3 Place the handset in the base unit for 15-20 hours without interruption. The base unit’s LED light (labeled CHARGE) illuminates once the handset is placed in the base. The LED light will illuminate whether the battery pack is connected or not.

If the base CHARGE LED light does not illuminate:

•Check to see if the AC adapter is plugged into the base unit and the electrical wall outlet properly.

•Check to see if the handset is sitting correctly in the base and making good contact with the base unit’s charging contacts.

Notes:

•Connect the AC adapter to a continuous power supply.

•Place the base unit close to the AC outlet so that you can unplug the AC adapter easily.

•It is normal for the handset and base to get warm, when the handset is charging in the base unit.

IMPORTANT

•Use only the supplied SANYO AC adapter. Do not use any other AC adapter.

•Do not place the power cord so that it creates a trip hazard or where it could become damaged and create a fire or electrical hazard.

E7