Installing the Ni-Cd battery
1Loosen the rear cover fixing screw (A) and open
the cover. (The screw cannot be removed from
the cover.)
2Insert the battery into the battery compartment
so that the Ni-Cd battery label is facing upward.
3Connect the battery plug to the connector.
4Close the rear cover and tighten the rear cover
fixing screw (A).
A
1
3
2
WARNING
•Do not short the battery terminals and do not
attempt to disassemble or modify the battery.
•Do not drop the battery or subject it to strong
shocks.
•Do not place the battery into fire, as it may
explode.
•Do not expose the battery to moisture.
•Do not place the battery into water or let the
terminals of the battery get wet.
DANGER
The following precautions must be observed at all
times, otherwise the battery may leak, overheat or
explode.
•Never peel off or scratch the outer tube.
•Do not use in any other appliance except for
this camera.
•Do not carry the battery by holding the
connectors or lead wires.
If the fluid inside the battery gets into eyes, it may
cause blindness. Do not rub the eyes, wash the
affected area immediately with clean water, and
then seek medical advice.
If the fluid inside the battery gets onto the skin or
clothing, it may injure the skin, so wash the
affected area immediately with clean water.
L42A4/US (DSR-C100) GB 2001, 4, 16
12 English