HARD DISK STANDBY MODE

When shooting or recording ends, switch the hard disk to standby mode.

Setting to standby mode

1Press the MENU button.

The MAIN MENU screen will be displayed.

 

(MAIN MENU)

MENU

RECORD START

 

PLAYBACK

 

SETTINGS

 

CONDITION

2While pressing the MENU button, press the SET button.

After the current image has been recorded on the hard disk, the disk will change to standby mode. During recording, the message “DISK CLOSING” will be displayed for approximately 2 seconds.

Furthermore, the warning indicator and caution indicator will both switch off while the hard disk is in standby mode.

MENU SET

DISK CLOSING

Note:

The caution indicator will flash until the hard disk changes to standby mode. None of the setting details will change when the hard disk is in standby mode.

This operation (DISK CLOSING) cannot be carried out using the camera control unit (sold separately).

Canceling standby mode

If you press the MENU button, the MAIN MENU screen will be displayed.

To start pre-alarm recording, select RECORD START and then press the SET button. Furthermore, if the MAIN MENU screen remains displayed for 30 seconds, the camera will change automatically to pre-alarm recording.

Press the MENU button.

Pre-alarm recording will then start.

PRE1-ALARM REC

MENU

REMAIN SHOTS: 6834

Note: The warning indicator and caution indicator will both flash while the hard disk contents are being checked. When pre-alarm recording starts, the caution indicator will light.

18

English

Page 19
Image 19
Sanyo DSR-C100 Hard Disk Standby Mode, Setting to standby mode, Canceling standby mode, Press the Menu button