Sanyo PLC-WL2503A owner manual Direct on, Note, Min . Only set to Count down , Timer is

Setting

Direct on

When this function is set to On, the projector will be automatically turned on just by connecting the AC power cord to a wall outlet.

Note:

Be sure to turn off the projector properly (see “Turning Off the Projector” on page 20). If the projector is turned off in the incorrect sequence, the Direct on function does not work properly.

P-timer

This function allows you to change the presentation of the P-timer		P-timer
and execute it.
Select one of the following options:
Count up	The P-timer display 000:00 appears on the
Count down	screen and the count starts (000:00-180:00)
	The time set in the Timer setting appears on the
Timer	screen and the countdown starts.
	Use the Point ▲▼ buttons to set the Timer
	(1-180 Min). Only set to Count down, Timer is
Start	active. Factory default value is 10 Min.
	It executes the count up or count down
	function. Press the SELECT button at Start
	and the indication changes into Stop. To stop
	Count up or Count down, press the SELECT
	button at Stop on the screen menu, then the
Reset	indication changes into Restart.
	Reset the P-timer values.
	Press the SELECT button at Reset to return to
	the following value;
	Count up ... "000:00"
Exit	Count down ... Timer that you set
	To exit the P-timer operation.

Stop or Cancel the P-timer via Remote Control To stop the P-timer, press the P-TIMER button.

To cancel the P-timer, press and hold the P-TIMER button for a few seconds.

52