Sanyo PLC-XC56 owner manual Setting, Power management, Shut down, Note, On start, Standby mode

Setting

Power management

For reducing power consumption as well as maintaining the lamp life, the Power management function turns off the projection lamp when the projector is not operated for a certain period.

Select one of the following options:

Ready	When the lamp has been fully cooled
	down, the POWER indicator changes
	to green blinking. In this condition,
	the projection lamp will be turned on if
	the input signal is reconnected or any
	button on the top control or remote
Shut down	control is pressed.
	When the lamp has been fully cooled
Off	down, the power will be turned off.
	Power management function is off.
Timer	If the input signal is interrupted and
	no button is pressed for more than
	30 seconds, the timer display with
	No signal appears. It starts the
	countdown until the lamp is turned off.
	Use the Point ▲▼ buttons to set the
	Timer(1~30min).

Note:

Factory default is Ready: 5 min.

On start

When this function is set to On, the projector will be automatically turned on just by connecting the AC power cord to a wall outlet.

Note:

Be sure to turn off the projector properly (see “Turning Off the Projector” on page 20). If the projector is turned off in the incorrect sequence, the On start function does not work properly.

Standby mode

This function is available when operating the projector via network.

Network..... Supply the power to the network function even

after turning off the projector. You can turn on/ off the projector via network, modify network environment, and receive an e-mail about projector status while the projector is powered off.

Eco............. Select Eco when you do not use the projector

via network. The projector’s network function will stop when turning off the projector.

Refer to the owner’s manual “Network Set-up and Operation”.

Power management

Time left before Lamp is off.

Closed caption

Ready

Note:

•Factory default is Network.

•When selecting Network, the cooling fans may be running depending on the temperature inside the projector even if the projector is turned off.

51