Sanyo PLC-XC56 Maintenance and Cleaning Resetting the Lamp Counter, Lamp Handling Precautions

Maintenance and Cleaning

Resetting the Lamp Counter

Be sure to reset the Lamp replacement counter after the		Lamp counter
lamp is replaced. When the Lamp replacement counter is
reset, the LAMP REPLACE indicator stops lighting.
1	Press the MENU button to display the On-Screen
	Menu. Use the Point ▲▼ buttons to select the Setting
	and then press the Point ► or SELECT buttons.
2	Use the Point ▲▼ buttons select Lamp counter and
	then press the Point ► or SELECT button. Use the
	Point ▲▼buttons to select Lamp counter reset and
	then press SELECT button. The Lamp replacement
	counter Reset? appears. Select Yes to continue.
3	Another confirmation dialog box appears, select Yes to
	reset the Lamp counter.

The Lamp replacement counter Reset? appears.

Select Yes, then another confirmation box appears.

Select Yes again to reset the Lamp counter.

LAMP HANDLING PRECAUTIONS

This projector uses a high-pressure lamp which must be handled carefully and properly. Improper handling may result in accidents, injury, or create a fire hazard.

●Lamp life may differ from lamp to lamp and according to the environment of use. There is no guarantee of the same life for each lamp. Some lamps may fail or terminate their life in a shorter period of time than other similar lamps.

●I�f the projector indicates that the lamp should be replaced,�� i.e.,�� if the LA�MP REPLA�CE indicator lights up, replace the lamp with a new one IMMEDIATELY after the projector has cooled down.

(Follow carefully the instructions in the Lamp Replacement section of this manual.) Continuous use of the lamp with the LAMP REPLACE indicator lighted may increase the risk of lamp explosion.

●A� Lamp may expl� ode as a result of vibration,�� shock�� or degradation as a result of hours of use as its lifetime draws to an end. Risk of explosion may differ according to the environment or conditions in which the projector and lamp are being used.

IF A LAMP EXPLODES, THE FOLLOWING SAFETY PRECAUTIONS SHOULD BE TAKEN..

If a lamp explodes, disconnect the projector’s AC plug from the AC outlet immediately. Contact an authorized service station for a checkup of the unit and replacement of the lamp. Additionally, check carefully to ensure that there are no broken shards or pieces of glass around the projector or coming out from the cooling air circulation holes. Any broken shards found should be cleaned up carefully. No one should check the inside of the projector except those who are authorized trained technicians and who are familiar with projector service. Inappropriate attempts to service the unit by anyone, especially those who are not appropriately trained to do so, may result in an accident or injury caused by pieces of broken glass.

65