Sanyo PLC-XC56 owner manual Maintenance and Cleaning Lamp Replacement, Service Parts No 339

Connect the AC power cord to the projector and turn on the projector.

Turn off the projector and disconnect the AC power cord. Allow the projector to cool for at least 45 minutes.

Loosen the screw with a screwdriver, slide and open the lamp cover.

Loosen 2 screws of the lamp with a screwdriver and pull out the lamp upwards vertically by grasping the handle.

Maintenance and Cleaning

Lamp Replacement

When the projection lamp of the projector reaches its end of life, the Lamp replacement icon appears on the screen and LAMP REPLACE indicator lights yellow. Replace the lamp with a new one promptly. The timing when the LAMP REPLACE indicator should light is depending on the lamp mode.

Note:

•When Mode 2 is selected in the Lamp life control menu, if the projection lamp of the projector reaches its end of life, the lamp replacement icon appears on the screen, and the projector is turned off automatically after 3 minutes.

•The Lamp replacement icon will not appear when the Display function is set to Off (p.46), during Freeze (p.25), or No show (p.26).

Top Control

Lamp replacement icon

LAMP REPLACE indicator

CAUTION

Allow a projector to cool for at least 45 minutes before you open the Lamp Cover. The inside of the projector can become very hot.

CAUTION

For continued safety, replace with a lamp of the same type. Do not drop a lamp or touch a glass bulb! The glass can shatter and may cause injury.

CAUTION

When replacing the lamp because it has stopped illuminating, there is a possibility that the lamp may be broken. If replacing the lamp of a projector which has been installed on the ceiling, you should always assume that the lamp is broken, and you should stand to the side of the lamp cover, not underneath it. Remove the lamp cover gently. Small pieces of glass may fall out when the lamp cover is opened. If pieces of glass get into your eyes or mouth, seek medical advice immediately.

Follow these steps to replace the lamp.

1

2

3

4 Replace the lamp with a new one and tighten the 2 screws back into position. Make sure that the lamp is set properly. Replace the lamp cover and tighten the screw.

5

6 Reset the lamp replacement counter..

See "Resetting the Lamp Counter" on the next page.

Lamp Cover

	Screw
Screw	Handle
	Screw

Lamp

ORDER REPLACEMENT LAMP

Replacement lamp can be ordered through your dealer. When ordering a projection lamp, give the following information to the dealer.

●	Model No.. of your projector	: PLC-XC56
●	Replacement Lamp Type No.	: POA-LMP127
		(Service Parts No. 610 339 8600)

64