Sanyo PLC-XC56 Maintenance and Cleaning Replacing the Filter Cartridge, Recommendation

Maintenance and Cleaning

Replacing the Filter Cartridge

1	Turn off the projector, and unplug the AC power cord
	from the AC outlet.
2	First, clean up the dust on the projector and around the
	air vents.
3	Loosen 2 screws of the filter cover with a screwdriver
	and open the filter cover.
4	Rotate the handle of the filter and pull out the filter
	cartridge.
5	Put the new one back into the position and rotate back
	the handle. Make sure that the filter cartridge is
	properly and fully inserted. Close the filter cover and
	tighten the 2 screws back into position.
6	Connect the AC power cord to the projector and turn
	on the projector.
7	Reset the filter counter and the scroll counter (p.62).

CAUTION

Make sure the filter cartridge is inserted in the projector. If the filter cartridge is not inserted, the projector cannot be turned on.

Do not put anything into the air vents. Doing so may result in malfunction of the projector.

RECOMMENDATION

We recommend avoiding dusty/smoky environments when operating the projector. Usage in these environments may cause a poor image quality.

When using the projector under dusty or smoky conditions, dust may accumulate on a lens, liquid crystal panels, or optical elements inside the projector. Such condition may degrade the quality of the projected image.

When the symptoms above are noticed, contact your authorized dealer or service station for proper cleaning.

ORDER REPLACEMENT FILTER CARTRIDGE

Replacement filter cartridge can be ordered through your dealer. When ordering, give the following information to the dealer.

●Model No. of your projector

PLC-XC56

●Replacement Filter Cartridge Type No.

POA-FIL-063

(Service Parts No. 610 339 7665)

Filter cover

Screws

CLOSE

handle

OPEN

handle

Filter cartridge

61