Sanyo SCP-4920 manual Using the Battery

Models: SCP-4920

1 78
Download 78 pages 48.57 Kb
Page 8
Image 8

Using the Battery

Installing the Battery

Your phone comes with a Li-Ion battery. Follow these steps to install it:

1.Place the battery into the space beneath the antenna with the metal contacts at the bottom, facing downward.

2.Gently press down until it’s in place and the battery release latch snaps.

Removing the Battery

To remove your battery,follow these easy steps:

1.Make sure the power is off so that you don’t lose any stored numbers or messages.

2.Push the battery release latch up and hold the battery.

3.Then pull it up and out at a 45-degree angle.

Charging the Battery

Your phone comes with a rechargeable battery. You should charge the battery as soon as possible so you can begin using your phone.

Keeping track of your battery’s charge is important. If your battery level becomes too low, your phone automatically turns off and you will lose all the information you were just working on. For a quick check of your phone’s battery level, glance at the battery charge indicator located in the upper-right corner of your phone’s display screen. If the battery charge is getting too

low, the battery icon appears and the phone sounds a warning tone.

Always use an approved travel charger or vehicle power adapter to charge your battery.

Warning! Using the wrong battery charger could cause damage to your phone and void the warranty.

Note: Long backlight settings, searching for service, vibrate mode, and browser use affect the battery’s talk and standby times.

Using the Travel Charger

To use the travel charger provided with your phone:

1.Plug the travel charger into a wall outlet.

2.Plug the other end of the travel charger into the side of your phone (with the battery installed).

Charging when your phone is turned on:

The battery icon appears on the display while charging.

The battery icon turns to when charging is complete.

Charging when your phone is turned off:

The battery icon appears, and the message “BATTERY CHARGING-Power Off-” is shown on the display while charging. When the battery is completely discharged, you may wait for several minutes until the message is shown on the display. The battery icon turns to , and message changes to “CHARGING COMPLETE-Power Off-” when charging is complete.

Tip: Be sure to watch your phone’s battery level indicator and charge the battery before it runs out of power.

6

7

Page 8
Image 8
Sanyo SCP-4920 manual Using the Battery