Sanyo SRT-8040P SYNCHRONIZATION CONTROL, Operator Mode, Connection, JOG, JOG, then, SHUTTLE, dial to, operated, operation, clockwise, ring clockwise, dial until the

SYNCHRONIZATION CONTROL

When two or more VCRs are connected together, the VCRs can be operated simultaneously just by operating the VCR that has been set to“MASTER”, without using a system controller (sold separately).

There are two modes available: operator mode and administrator/installer mode. The operations that can be carried out in each mode are different.

NOTES:

Operator Mode

This mode lets you carry out basic operations (ejecting, recording, stopping, rewinding, changing the recording speed mode and power on/stand-by).

NOTE:

œThis mode will not work correc in the same initial state.

œ The	operation		1 PressSTANDBY/ONthe button.
		and setting can only be carried out with
the	button of	this unit.	2 PressMENUthebutton to display the MAIN MENU.

	2
œ Use cables with a thickness)or of A.W.G.24 (0.2 mm
	3 TurnJOGthedial to select the“4.WARNING
more and a length no more than 1.5 m to connect
VCRs.	OUT/CONTR. SET” line, then turn the SHUTTLE
	ring clockwise.

œIt is recommended that you do not connect any more

øThe (WARNING OUT/CONTROL SET) menu

than 10 VCRs together.

appears.

œ Only one VCR can be specified at the master unit.
	<WARNING@OUT@SET>SET@UP
	ALARM@@@@@@@@@@@@Y
œ Do not mix operator mode and administrator/installerNON@REC@@@@@@@@@@N
mode in the same installation.	MECHA.PROBLEM@@@@Y

œDo not connect the VCRs in a loop.

œ“TERMINAL SET” in the (OTHERS) menu should always be set to “SET1”.

<CONTROL@SET>

EJECT@MODE@@@@@@@EJECT1

OPERATION@@@@@@@@SLAVE

	4 TurnJOGthedial until the“OPERATION” setting is
œ The VCR operation may not be completely
	highlighted, then turn the SHUTTLE ring clockwise.
synchronized depending on the VCR statuses, the
operating environment and the5 TurnoperationJOGthedial to timingselect the desired. Itoperation,is
recommended that you check thethenoperatingturn theSHUTTLE ringstatusesclockwise.
and menus after carrying out each operation.
	SLAVE . . . . . . . . . . . . . The function is restricted
Connection	to only the VCR being
	operated.

VCR No. 1	VCR No. 2
CONTROL IN COM CONTROL OUT	CONTROL IN COM CONTROL OUT

To CONTROL IN terminal

To COM terminal

MASTER . . . . . . . . . . The function is applied to the VCR being operated and all VCRs that are connected after it.

œWhen “OPERATION”the is set to “MASTER”, “SC” lights on the digital display.

6PressMENUtheEXIT button.

English 41