SETTING FOR RS-485 OR RS-232C USE

The RS-485 interface can be used to operate the VCR using a SANYO brand system controller. Furthermore, the RS-232C interface can be used to operate the VCR using a computer.

Settings when using RS-485

1 PressSTANDBY/ONthe button.

2PressMENUthebutton to display the MAIN MENU.

NOTES:

3 TurnJOGthedial to select the“9.OTHERS” line,

 

then turn the SHUTTLE ring clockwise.

œ This can only be used when the RS-485/232C

interface board (VZU-485/232C)

ø The (OTHERS) menu appears.

is installed.

œ Refer to the instruction manuals for <OTHERS>the

*ALARM@LOG

VZU-485/232C, the system controller and/or*POWER@FAILURE/DEWthe

*TERMINAL@SET@@@@SET1

computer.*RS-485@SET @@STATUS@INFO.@@@Y

Setting the Address and Data Transfer Speed

@@ALARM@INFO.@@@@Y

4 TurnJOGthedial until the“STATUS INFO.” setting

œ Make this setting without a cassette tape inserted.

is highlighted, then turn the SHUTTLE ring clockwise.

1PressCOUNTERthe RESET button for 3 seconds or more.

ø“485” or “232” appears on the digital display.

2TurnJOGthedial to select the interface being used,RS-232C or RS-485.

ø“232” or “485” appears on the digital display.

5TurnJOGthedial to set the“STATUS INFO.” setting, then turn the SHUTTLE ring clockwise.

Y. . . . . . . . . . The VCR status information is output at the RS-485 connector.

N . . . . . . . . . The status information is not output at the RS-485 connector.

œWhen setting“232”, carry out step 3 and step6.

then6 TurnJOGthedial until the“ALARM INFO.” setting is highlighted, then turn the SHUTTLE ring clockwise.

3 TurnSHUTTLEthe ring clockwise.4TurnJOGthedial to set the VCR address (from 000 to 127).

øThe address set appears on the digital display.

5 TurnSHUTTLEthe ring clockwise.

6TurnJOGthedial to set the data transfer speed (19200, 2400, 4800, 9600).

øThe data transfer speed set appears on the digital display.

7TurnJOGthedial to set the“ALARM INFO.” setting, then turn the SHUTTLE ring clockwise.

Y. . . . . . . . . . The VCR alarm information (alarm recording start and stop) and video loss information are output at the RS-485 connector.

N. . . . . . . . . The VCR alarm information (alarm recording start and stop) and video loss information are not output at the RS-485 connector.

7 When finished,COUNTERpressRESET buttonthe. 8 PressMENUtheEXIT button.

NOTE:

œWhen MENUthe RESET button is pressed, the setting appearing on the digital display is reset to the default setting.

9 Set TERMINATEthe switch on the back panel to the

“ON” or “OFF” position

OFF side . . . Not terminated

ON side . . . . Terminated

NOTE:

œWhen a warning state (non-reco problem or clog detection) occ output from the RS-485 connec

non-recording warning states“NON a

REC” is set to “N” in the (WARNING OUT/CONTROL SET) menu. In addition, the clog detection warning state is not output if “CLOG DETECT.” is set to “N” in the (GENERAL SET) menu.

English

43