OUTPUT TERMINALS
REMOTE Jack | Remote control setting |
Remote control of the VCR is possible by connecting a | The remote control switch 7 (see illustration at left) can |
remote controller with a circuit such as indicated below, be set to either eject the tape or access the menus. | |
to theREMOTE jack. | 1 PressSTANDBY/ONthe button. |
| |
NOTES: | 2 PressMENUthebutton to display the MAIN MENU. |
œ Use a 3.5 mm
œ The connection should be done line,usingthen turnathe shieldedSHUTTLE ring clockwise. cable no more than 5 meters longø.The (GENERAL SET) menu appears.
œ The functions not available on the VCR<GENERAL@SET>will not
operate.TAPE@IN@MODE@@@@@STOP
TAPE@END@MODE@@@@REW
CLOCK@ADJUST@@@@@01:00
œ You can use a
VIDEO@LOSS@@@@@@@N
separately) to control the VCR remotelyCLOG@DETECT. .@@@@@NThe
REMOTE@@@@@@@@@@@MENU
functions not available on the VCR willVIDEO@@@@@@@@@@@@COLORnot operate.
VERTICAL@SYNC@@@@Y
Remote control circuit
R0 1.2K
R1 0.3K
SW0: EJECT
SW1: STOP
4TurnJOGthedial until the“REMOTE” setting is highlighted, then turn the SHUTTLE ring clockwise.
5TurnJOGthedial to select the desired switch mode, then turn theSHUTTLE ring clockwise.
MENU. . . . . . Switch operates as anMENU buttonR2 0.43K
R3 0.51K
R4 0.62K
R5 0.75K
R6 0.91K
R7 1.1K
R8 1.3K
R9 2.0K
R10 2.4K
R11 3.6K
R12 5.6K
SW2: STILL/PAUSE | EJECT . . . . . Switch operates as anEJECT |
| button |
SW3: REW | 6 PressMENUtheEXIT button. |
SW4: FF |
|
SW5: PLAY |
|
SW6: REC |
|
SW7: MENU (or EJECT) |
|
SW8: REV |
|
SW9: REC/PLAY SPEED j |
|
SW10: REC/PLAYl SPEED
SW11: SHIFT]
SW12: SHIFT«
The resistance tolerance is 2% or less.
48 | English |