Sanyo SRT-8960 SYNCHRONIZATION CONTROL, Operator Mode, Connection, JOG, ring, SHUTTLE, operated, clockwise, dial until the, to only the VCR being, SHUTTLE ring clockwise

SYNCHRONIZATION CONTROL

When two or more VCRs are connected together, the VCRs can be operated simultaneously just by operating the VCR that has been set to“MASTER”, without using a system controller (sold separately).

There are two modes available: operator mode and administrator/installer mode. The operations that can be carried out in each mode are different.

NOTES:

Operator Mode

This mode lets you carry out basic operations (ejecting, recording, stopping, rewinding and changing the recording speed mode).

NOTE:

œThis mode will not work correc in the same initial state.

œ The	operation		1 PressMENUthebutton to display the MAIN MENU.
		and setting can only be carried out with
the	button of	this unit.	2 TurnJOGthedial to select the“4.WARNING

2OUT/CONTR. SET” line, then turn the SHUTTLE

œUse cables with a thickness)or of A.W.G.24 (0.2 mm more and a length no more thanring1.clockwise5 m to. connect

VCRs.	ø The (WARNING OUT/CONTROL SET) menu
	appears.
œ It is recommended that you do not connect any more
than 10 VCRs together.	<WARNING@OUT@SET>SET@UP
	ALARM@@@@@@@@@@@@Y
œ Only one VCR can be specified at the master unit.
	NON@REC@@@@@@@@@@N
	MECHA.PROBLEM@@@@Y

œ Do not mix operator mode and administrator/installer

mode in the same installation.

<CONTROL@SET>

œ Do not connect the VCRs in a loop.		EJECT@MODE@@@@@@@EJECT1
œ Do not connect the VCRs in a loop.		OPERATION@@@@@@@@SLAVE
		OPERATION@@@@@@@@SLAVE
œ “TERMINAL SET” in the (OTHERS) menu should	3 TurnJOGthedial until the“OPERATION” setting is
always be set to “SET1”.	3 TurnJOGthedial until the“OPERATION” setting is
always be set to “SET1”.	highlighted, then turn the SHUTTLE ring clockwise.
	highlighted, then turn the SHUTTLE ring clockwise.
œ The VCR operation may not e completely
	4 TurnJOGthedial to select the desired operation,
synchronized depending on the VCR statuses, the
	then turn theSHUTTLE ring clockwise.
operating environment and the operation timing. It is
	SLAVE . . . . . . . . . . . . . The function is restricted
recommended that you check the operating statuses
		to only the VCR being
and menus after carrying out each operation.
		operated.

Connection

VCR No. 1	VCR No. 2
CONTROL IN COM CONTROL OUT	CONTROL IN COM CONTROL OUT

To CONTROL IN terminal

To COM terminal

MASTER . . . . . . . . . . The function is applied to the VCR being operated and all VCRs that are connected after it.

œWhen “OPERATION”the is set to “MASTER”, “SC” lights on the digital display.

5PressMENUtheEXIT button.

English