OUTPUT TERMINALS

SW OUT Terminal

When recording, a pulse signal is output at theSW OUT terminal.

This terminal is usually connected to the switch input (SW IN) of devices like a camera switcher unit, or a quad compressor.

ΦΙΕΛΔ: 16.7 ∝σεχ.

ΦΡΑΜΕ: 5 ∝σεχ.

5V (H)(Output impedance: 5.7 Ω)k 0V (L)

8TurnJOGthedial to select the desired“8H” (or “6H”) mode, then turn the SHUTTLE ring clockwise.

œIf “TAPE”the in the (GENERAL SET) menu is set to “T-120”, “6H” will be indicated instead of “8H”.

Y. . . . . . . . . . When recording in 8-hour (or 6-hour) mode, a pulse signal is output.

N. . . . . . . . . . When recording in 8-hour (or 6-hour) mode, a pulse signal is not output.

9PressMENUtheEXIT button.

SW OUT Terminal Output Setting

1PressMENUthebutton to display the MAIN MENU.

2TurnJOGthedial to select the“2.DISPLAY/SW OUT SET” line, then turn the SHUTTLE ring clockwise.

øThe (DISPLAY/SW OUT SET) menu appears.

<DISPLAY@SET>@@@@SET@UP

DATE@@@@@@@@@@@@@Y

TIME@@@@@@@@@@@@@Y

SPEED@@@@@@@@@@@@Y

ALARM@COUNT@@@@@@Y

<SW@OUT@SET>

TIMING@@@@@@@@@@@FIELD

FIELD@@@@@@@@@@@@1

8H@MODE@@@@@@@@@@Y

3TurnJOGthedial until the“TIMING” setting is highlighted, then turn the SHUTTLE ring clockwise.

4TurnJOGthedial to select the desired output timing, then turn theSHUTTLE ring clockwise.

FIELD. . . . . . 1 pulse is output after each setnumber of fields.FRAME . . . . 1 pulse is output after each set number of frames.

5 TurnSHUTTLEthe ring clockwise.

6TurnJOGthedial to select the desired pulse signal interval (1, 2, 3, 4, 5, 10, 30 or 60), then turn the SHUTTLE ring clockwise.

œIf“TIMING” is set to FRAME (see step 4), “FRAME” will be indicated instead of “FIELD”.

7 TurnSHUTTLEthe ring clockwise.

46

English