Sanyo TLS-224P Alarm Recording Counter Display, Connections to the Alarm IN/OUT, Terminals

ALARM RECORDING

Alarm Recording Counter Display

•During alarm recording, “AL” will be flashing on the digital display.

•If the ON SCREEN switch is set to the “ON” position, the number of alarms will flash on the monitor screen.

•The maximum display number of alarm triggers is “999”, at the next alarm recording the counter will indicate “000”.

•When the (ALARM TIME) menu is displayed, press the MENU RESET button to reset the alarm counter to “000” (all the data of the (ALARM TIME) menu is reset).

GB	Connections to the ALARM IN/OUT
	Terminals
	• Alarm input signal
	Connect a make-contact (no voltage) switch between
	the ALARM IN and COM terminals.
	• Alarm output signal
	Normally DC 5V are output between the ALARM
	OUT and the COM terminals. When an alarm input
	(trigger) is received and the unit is recording, the
	output falls to 0V. Once the alarm recording is over,
	the output returns to DC 5V.

Checking the Alarm Recordings Time

1Press the AUDIO ON/MENU button until the (ALARM TIME) menu is displayed.

°The number of alarm triggers, and the 8 most recent alarm recording times are displayed.

Example

<ALARM TIME> 008 12-12 19:00 12-11 23:00 12-11 15:00 11-10 08:00 11-10 06:00 10-09 20:00 10-09 16:35 10-09 10:52

NOTE:

•The data for the previous alarm recordings is erased.

2Press the PAUSE/SCAN button, the normal screen is displayed.

NOTE:

•If the MENU RESET button is pressed while the (ALARM TIME) menu is displayed, the displayed data is erased.

“AL” will be erased from the digital display.

English 15