Accessories Installation, Interface Module Upgrade | SATO 5900RVe

Unit 3: Installation

ACCESSORIES INSTALLATION

In most instances, the printer is ordered with the desired accessories pre-installed. However, changes in printing conditions or requirements does warrant upgrades from time to time.

This chapter of the manual covers the installation procedures of accessories that are deemed suitable for the owner/operator to perform. For all other accessory upgrades or installatins, contact the SATO Technical Support Dept.

INTERFACE MODULE UPGRADE

The printer is typically ordered with a high-speed parallel interface board installed. However, interface requirements sometimes change and an upgrade is desired. All of the interface boards are installed within the same slot located in the rear of the printer with little or no difference in installation methodology.

Simply remove the two screws (1) securing the existing interface board (2) to the printer (3). Replace the exisiting board with the upgrade and secure with the two screws.

2

1

3

Figure 3-3, Interface Board Upgrade

SATO M5900RVe Operator Manual

PN 9001125A

Page 3-10

Image 24

SATO 5900RVe manual Accessories Installation, Interface Module Upgrade

Contents

M5900RVe Direct Thermal Printer Sato America, Inc Table of Contents Troubleshooting MaintenanceOperation Introduction About this Manual Result in Presonal Injury General Description 1a, Primary Components 1b, Primary Components Control Features SwitchesPage Technical Data Physical Characteristics PowerEnvironmental Print Character Font Capabilities Downloadable Fonts Character ControlBAR Code Capabilties Regulatory Approvals Installation Unpacking & Parts Identification Packed Components Printer Installation Site LocationMedia Selection Media Loading Media Loading RS232C Specifications Interface SelectionRS232 Serial Interface RS232C Serial Interface Signals PIN Direction Signal DefinitionCable Requirements DB9 Host Connection DB9 Printer Specifications IEEE1284 Parallel InterfaceACK Init 802.11B Wireless 80211B Wireless SpecificationsUniversal Serial BUS USB Adapter Local Area Network LAN Ethernet Receive Buffer ACK/NAK Protocol Accessories Installation Interface Module Upgrade Operation Printer Configuration DIP Switch Panels DSW1 Default Settings DSW1 ConfigurationDSW1 Function Descriptions OFF DSW2 Default Settings DSW2 Configuration DSW1Configuration DSW2 Function Descriptions DSW3 Default Settings Function Description Configuration Modes Normal Mode Test Print Mode Test Print Mode Advanced Mode Advanced Mode Default Settings Mode Default Settings Mode Flash Memory Download Mode Download Font Deletion Status Description Acsii HEX Transfer Flash Memory Download Mode User Download Mode User Download Mode HEX Dump Mode Hex Dump Mode Card Mode Card Mode NON-STANDARD Clear Mode Non-Standard Clear Mode Service Mode 10, Service Mode Counters Mode 11, Counters Mode Maintenance Mode Maintenance Mode Advanced Mode Card ModeMenu Description Service Mode Counters Mode Maintenance Mode Operational Adjustments Potentiometer DESCRIPTION/PROCEDUREPrint Offset Feed Direction 14, Sensor & Accessory Locations Unit 4 Operation Sato M5900RVe Operator Manual PN 9001125A Troubleshooting LCD Message Beep Error Condition To Clear Image Voids Light Print ImagesUneven Print Darkness Smeared Print Images Meandering Media Printer Creates a Blank LabelIncorrect Label Positioning Troubleshooting Procedures Universal Serial BUS USB Interface Parallel Interface LAN Ethernet Interface Page Maintenance Cleaning Procedures From the PRINTER, Exersize Care to Prevent Print Head Damage Replacement Procedures Fuse Replacement Print Head Replacement Print Head to Prevent Damage to ITS Elements Interface Board Replacement Interface Board Replacement Adjustment Procedures Print Defects Relative Procedure Print Head Balance Adjustment Print Head Balance Adjustment Print Head Alignment Print Head Alignment