SATO ct4i manual Configuration Panel, DIP Switch Settings, Led

Unit 4: Printer Configuration

4.3 THE CONFIGURATION PANEL

The Configuration Panel is accessible when you lift up the top cover.

The panel consists of an eight-position DIP switch, three adjustment potentiometers and a seven- segment LED Error Status display. Receptacles for connecting the optional Cutter (factory installed) are also located on this panel.

DIP switch for Configuration

VR1 potentiometer

Paper handling Reserved

Head Check VR1 adjust DATA Dump

Reserved

Error

Status

LED

DIP SWITCH SETTINGS

This is an eight-position switch used for setting the operating conditions of the printer. Switches 1 to 3 act as control for both paper handling and the loading of programs or fonts into the printer.

Switches 1–3: Paper Handling settings
These three switches select the method used for	DSW1	DSW2	DSW3	Mode
controlling paper handling:
	Off	Off	Off	Continuous
Continuous mode - (default mode) Does not use the	Off	Off	On	Linerless
	On	Off	Off	Tear Off
sensor for paper indexing. The paper movement will
	Off	On	Off	Cutter
stop after all the label data has been printed.
	On	Off	On	Program
Tear Off mode - Paper is fed out to the cut/tear off				Download
				Mode
position after printing is complete. Before the next label
	Off	On	On	Load Font
is printed, the paper is pulled back in to the first print
line position.

Configuration Switch

Cutter mode - Enables the Cutter option if installed.

ON

OFF

1 2 3 4 5 6 7 8

CT4i Series Operator Manual 4-4