Setup
2-13
Installing the label r oll (cont’d)
3. Lift up the label guide adjust
dial cover and turn the dial
till the label guides press
loosely against label roll.
Turn the label roll lightly by
the hand and confirm that it
rotates smoothly. Otherwise
paper may not be fed
correctly during operation.
Close the dial cover.
* When replacing a label roll
of the same width as that
used previously,
adjustment of the label
guide is not necessary.
4. Close the cover after confirming that the leading
edge of the label is outside the printer.
This completes the label installation for
continuous mode operation.
MB20xi A6.book Page 13 Friday, May 27, 2005 5:12 PM