Setup
2-12
Installing the label roll
The method of installing label media varies with
your choice of the two possible print modes—
’continuous’ or ‘dispense’ mode.
1. Make sure you can see the
red platen roller. If not, slide
the dispenser unit down, by
lifting its top edge upwards
at the two arrow marks.
Now push the dark gray
Cover Open/Close lever
downwards to release the
cover.
2. Place the label roll into the
printer. Make sure the label
roll is placed with the first
label feeding from the
bottom of the roll and not
from the top (see picture).
Ensure that the first label
emerges from the bottom
(not top) of the roll.
Dispenser
unit
MB20xi A6.book Page 12 Friday, May 27, 2005 5:12 PM