Setup
Installing the label roll (cont’d)
3.Close the cover after confirming that the leading edge of the label is outside the printer by at least 10mm.
*When using non- separate labels, press the FEED button to feed a piece of label and pull the label upward to cut it along the perforation. If the label becomes jammed, retry the label setting procedure.
4.Push the dispenser unit forward so that it covers the red platen roller.
This completes the label installation for Dispense mode operation. To resume operation in Continuous mode, lift the top edge of the dispenser unit (where two arrow marks are imprinted) to it downwards. In Continuous mode, the red platen roller will be visible.
