Schneider Electric 174 CEV

Configuring the Bridge

3.10 Clearing theBridge’sConfiguration

Youmaywant toclearthe bridge’s currentsetup:itsIPconfiguration and mapping

tables.Forexample,ifyou intend toreinstall the bridge intoadifferentapplication

you maywishto assign a newconfiguration tothe bridge forthatapplication.

Youwill be using the CFGUTIL utilitytoclearthe bridge’s configuration.Here are

the steps.

Setup

If akeyboard and monitorare already connected tothe bridge,stop the bridge by

pressing Qand confirming thatyou want to quit the bridge application.

If akeyboard and monitorare notconnected,remove powertothe bridge and

connect themtothe bridge’sconnectorpanel.Restore powertothe bridge. If the

bridgedoesnotdisplayitsCFGUTILmenu,stop the bridge application bypressing

Qand confirming thatyou want to quit the bridge application.

Clearing theConfiguration

At the C:\ prompt, enter:CFGUTILtostart the configuration utility.

TheCFGUTILmenu should nowbe displayed.An exampleis showninFigure 14.

Yourmenushould display yourcurrentconfiguration forthe bridge.

Edit the CFGUTILmenu fieldsasfollows:

HIP Address:Enterbootpintothisfield.

HNetMask:Clearthisfield.

HNameServer:Clearthisfield.

HGateway:Clearthisfield.

HDomain:Clearthisfield.

When you finish editing the fields,press Escape.Youwill be prompted:

Write files to disk?

EnterYtosavethe configuration.Thiswill returnyou tothe C:\ prompt.

Deletethe fileC:\RTE.CFG.

The bridge will nowbe cleared toitsoriginalconfiguration.