Schneider Electric 174 CEV

DiagnosticTools

6.3TCPINFO

TCPINFOisprovidedto diagnoseBOOTPserverproblems. Ifyou have aBOOTP

serverand cannotaccess the bridge fromit, run TCPINFOinthe bridge and tryto

access the bridge again.The programisrun fromthe bridge’scommand line.

Setup

If akeyboard and monitorare already connected tothe bridge,stop the bridge by

pressing Qand confirming thatyou want to quit the bridge application.

If akeyboard and monitorare notconnected,remove powertothe bridge and

connect themtothe bridge’sconnectorpanel.Restore powertothe bridge.

If the bridge displays itsCFGUTILmenu,press Escape toclosethe menu.This

should displaythe bridge’sC:\>prompt.

Starting

Tostartthe TCPINFOprogram,enter:TCPINFO

Afteramaximumof30 seconds,TCPINFOshouldreportwhetherthe bridge can

be configured byBOOTP. If itcannotbe configured byBOOTP,you will need to

run the CFGUTILconfiguration program.

6.4BDRESET

BDRESETinitializesthe bridge’sModbusPluscard,asin power--up of the bridge.

The programisrun fromthe bridge’scommand line.

Setup

Setup the bridge withakeyboard and monitorasdescribed forTCPINFO.Note

thatremoving powertoconnect the keyboard and monitorwill alsoinitializethe

bridge (without the need torun BDRESET).Howeveryou mightwant to havethe

keyboard and montiorconnected torun furtherdiagnostics.

Starting

Tostartthe BDRESETprogram,enter:BDRESET/s5d

Youshouldsee the bridge nowattempting tojointhe ModbusPlusnetwork,as

indicated initsModbusPlusLEDs.Section 2.7 describesthe LEDpatterns.