Using the Logic Editor
136 372 SPU 780 01EMAN May 2002
Exiting Offline
Edit Mode From the logic editor right-click menu:
Undoing and
Redoing Edits Use the undo/redo feature to reverse or reapply up to 10 actions.
To Undo/Redo an
Edit From the logic editor, right-click menu:
Step Action
1 Select Edit → Offline Edit Mode.
-or-
Select Edit → Save Network. (Only visible when in offline network mode.)
-or-
Exit the logic editor.
2 You are then prompted about writing your changes to the controller:
Yes: ProWORX 32 checks the new network for undefined addresses and
duplicate coils. If none are found, ProWORX 32 deletes the original network
in the controller, and sends the new network (created in Offline Mode) to the
controller.
No: Returns to regular logic editor.
Cancel: Returns to Offline Edit Mode.
Note: If you receive the messages "Undo information not recognized, clearing
undo/ redo information", a possible cause could be the register ranges t hat are se t
for the PRWX loadable are being overwritten by theTraffic Cop, Peer Cop, MSTR,
or other instruction addresses that are already used. Search for address conflicts
with the Used Address feature, see Address Used, p.60.
Step Action
1 Select Edit → Undo or Edit → Redo. The Undo/Redo Stack dialog appears.
2 Click in the list where you want the starting point of the actions redone/undone.
The rows (actions) above the selected action are also selected.
3 Click OK to undo or redo the selected actions.