Schneider Electric TSXCUSBMBP user manual Installing the Tsxcusbmbp Driver Software

Installation

Installing the TSXCUSBMBP Driver Software

Introduction

How to install the

TSXCUSBMBP Driver?

The TSXCUSBMBP Driver must be installed before connecting the TSXCUSBMBP device to the USB port.

Use the following procedure to install the Driver software.

Step Action

1Insert the CD-ROM labeled TSXCUSBMBP Driver into your CD-ROM drive.

2The installation should begin automatically. If not, follow the procedure below to start the installation manually.

z From the Start menu (Start button on Windows XP task bar), select Run

z Type in D:\Setup.exe (if your CD-ROM drive is not D:, substitute the drive letter of your CD-ROM drive) and press Ok.

3Follow the on-screen instructions to complete the software installation.

4The final step of the software installation will display a message window containing instructions. Please read the instructions carefully.

Installing the TSXCUSBMBP Hardware

Introduction The TSX C USB MBP can be connected directly to a USB port on the PC or through a USB Hub. The TSXCUSBMBP acquires power from the USB port or Hub, therefore no power connection is required.

Note: Do not connect the Modbus Plus network cable to the Modbus Plus port on the TSXCUSBMBP until after the Modbus Plus Node Address has been configured in the Driver Software. This will avoid the potential for duplicate Modbus Plus node addresses on your network.

35011984 02/2006 17