Schneider Electric TSXETG100 manual Snmp Parameters

63230-319-211A1	ConneXium™ Ethernet Gateway
2/2006	Setup

SNMP Parameters	The ETG supports SNMP, allowing a network administrator to remotely
	access an ETG with an SNMP manager and view the networking status and
	diagnostics in the MIB2 format.
		Action	Result
	1.	From the Setup page, click SNMP	Opens the SNMP Parameters page.
		Parameters.
	2.	Check Enable SNMP to turn ON the simple	Activates SNMP.
		network management protocol.
		NOTE: If you uncheck Enable SNMP and
		click Apply, the ETG will reboot and SNMP
		functionality will be turned OFF.
	3.	Enter the system contact, system name,	Enters the SNMP system information and
		system location, read-only community	community access names.
		name, and the read-write community name.
	4.	Click Apply.	Saves the SNMP settings.

Figure 11: SNMP Parameters Page

ENGLISH

© 2006 Schneider Electric. All Rights Reserved. 13