Serial Port, Setup, Default Master | Schneider Electric TSXETG100

Serial Port

	Action	Result

1.	From the Setup page, click Serial Port.	Opens the Serial Port page.

2.	Select your mode, physical interface,	Selects the serial port options.
	transmission mode, baud rate, parity, and
	response timeout (see Table 4 on page 7).

3.	If you select Slave mode, enter the IP	Enters the IP addresses of the remote devices.
	addresses for the remotely connected
	devices (see Table 4 on page 7).

4.	Click Apply.	Updates the ETG Serial Port settings.

Option	Description	Setting

Mode	Used to select how the COM port on the	Master, Slave
	ETG is utilized (master or slave).	Default: Master
		Default: Master
	NOTE: When the Mode is changed, the
	ETG reboots.

Physical Interface	Used to select how the ETG serial port is	RS485 4-wire, RS485 2-wire,
	physically wired.	or RS232
		Default: RS485 2-wire

Transmission	Used to select how data is transmitted over	Modbus RTU, Modbus ASCII
Mode	a serial connection.	Default: Modbus RTU
		Default: Modbus RTU

Baud Rate	Used to select the data transmission speed	2400, 4800, 9600, 19200,
	over a serial connection.	38400, 56000, 57600
		Default: 19200

Parity	Used to select if data is checked for	Even, None
	accuracy using a parity bit.	Default: Even
		Default: Even

Response Timeout	Used to select how long the ETG will wait	0.1 to 10 seconds
	to receive a response from a serial device.	Default: 3 seconds

Remote Modbus	Used to define a list of Modbus TCP/IP	—
TCP/IP	addresses for the ETG to use during slave
Connections	mode communications.
(Slave mode only)

* Available only if the physical interface and transmission mode is RS232/Modbus ASCII.

ENGLISH