C0522 through C1030
Remote Condenser Models - User Manual
Panel Removal
1.Locate and loosen the two screws at the front edge of the top panel.
2.Pull the front panel out at the top and lift it up and off the base.
3.Remove two screws at the front edge of the top panel, and lLift up the top panel until it clears the front of the side panels, then push back 1” and lift it up and off the machine.
4.Locate and loosen the screws holding each side panel to the base.
5.Pull the side panel forward to release it from the back panel.
This manual covers several models of remote cubers. The model number on the ice machine can be found either on the dataplate, which is on the back panel, or the serial number tag, which is behind the front panel. See the illustration for the locations of the dataplate and the serial number tag.
The remote condenser has a separate model and serial number. Its model and serial number is on the dataplate on the condenser near the quick connect fittings.
Write the model and serial numbers here:
Model | Serial Number |
Ice machine
Bin
Condenser
Write the day of start up here:_______________
Switch Bezel
All models ship with the On and Off switches front accessible. if desired, the On and Off switches can be covered up to prevent unauthorized use by changing the bezel in the front panel's trim strip. A cover up bezel ships loose with the machine.
See the label on the front panel for instructions on changing the bezel.
5
3 | Dataplate | |
1. Remove | Location | |
| ||
Screws |
| |
2 |
| |
Serial | 5 | |
Plate |
| |
2 | 4. Remove | |
Screws | ||
|
Dataplate Location and Panel Removal
Uncrate and Set Up
Begin with the ice storage bin or dispenser. If a bin, remove the carton, and, using part of the carton as a cushion, tip the bin on its back to remove the skid. Attach the supplied legs or optional casters. Return the bin to a normal, upright position.
Check the bin top gasket for rips or gaps. If recycling an older bin, replace the gasket or repair with food grade sealant prior to placing the ice machine on the bin.
Install the bin top adapter or ice dispenser adapter, if one is required for the application.
If the ice machine has not been unpacked, do so now. Remove the carton from the skid. Lift the ice machine off the skid directly onto the bin.
Note: The machine is heavy. Use a mechanical lift if necessary.
Secure the ice machine to the bin with the hardware provided (two metal straps and four bolts).
Place the bin and ice machine in the selected location and level it using the bin leg levelers.
July 2006
Page 8
