CME1356R and CME1656R
Stacking - Kit KSCME6-LG-B
Only like models may be stacked. Begin after the bottom unit has been placed on the ice storage bin and secured. Stacking requires heavy duty leg kits. Casters are NOT recommended.
Note: Instructions are for either model.
Bottom Machine:
1.Remove front panel, left side panel, and top panel.
2.Remove & discard top cover from over the freezing compartment.
3.Install gasket materials to freezing compartment:
Cut about 22" of gasket material from the roll in the kit. Apply it to the back side top edge of the freezing compartment.
Cut two lengths of gasket material to fit the right side top edge of the freezing compartment and apply them.
4.Place a bead of food grade sealant to the top of the back wall’s gasket.
5.Place the shield bracket (has a large hole in the center) from the kit over the center of the freezing compartment.
Insert the tabs of the bracket into slots on the back of the unit.
6.Secure bracket at the front with screws from the kit.
7.Hang the plastic shields from the bracket installed in the prior step. Use the slots in the shields to hang them from the stainless steel hooks.
Note: The notch in the bottom of the shield goes to the front.
Note: The tabs on the shields must fit inside the ice outlet port.
8.Check the position of the shields. They must move freely and be vertical.
Note: The suction line may need to be moved slightly so the tubing clears the bracket & shields.
9.Place a bead of food grade sealant onto the top left edge of the freezing compartment.
10.Install the
11.Remove two existing screws and secure the bracket to the: freezing compartment, back panel and front channel with the 2 existing screws and 1 large and 4 small screws from the kit.
Both Machines:
12.Place the top ice machine onto the bottom one. Secure together with hardware from the top machine. Remove left front and left side panels.
13.At the back of the ice machines, on the compressor end, remove the upper
14.Place a strain relief (from the kit) into each hole.
15.Insert wire harness from kit thru
NOTE: Harness is marked which end goes to which machine.
Bottom Machine:
16.Remove harness from controller terminal 7 and bin thermostat.
17.Route wire harness in lower ice machine to the controller. Connect to terminal #7. Plug the two free wires onto the thermostat terminals #1 and #2.
18.Return left side panel to its original position on the lower ice machine.
Top Machine:
19.Remove harness from controller terminal 7.
20.Route wire harness thru upper unit’s lower
7of the controller.
21.Return all panels and covers to their normal positions.
22.Complete the balance of the installation. Service Notes:
A. The shields must be positioned so they hang vertically and move freely left to right. Their purpose is to guide the ice past the bottom machine’s evaporators and into its cube port.
B. The drain lines from each ice machine must be kept separate.
May 2001
Page 8
