SCCG50 & SCCP50
Service Manual
Installation: Water & Drain
The recommended water supply tubing is ¼ inch OD copper. Stainless steel flex or reinforced PVC tube may also be used. Install an easily accessible
Note: Do not use
1. Remove the front service panel.
Screw
Securing
Front Service
Panel
2.Route the tubing through the right hole in the back to the inlet water solenoid valve inlet.
3.Install a compression fitting on the tubing and connect to the inlet of the solenoid.
Drains
There are two types of ice machine models, one that drains by gravity and one that has an internal drain pump.
Drain Pump Model drain installation
1.Locate the coil of 3/8” ID plastic drain tubing secured to the back of the unit.
2.Route the plastic drain tube from the back of the unit to the drain connection point.
IMPORTANT NOTE: Often an air gap is required by local codes between the ice maker drain tube and the drain receptacle.
Water Inlet Tube (field supplied)
Drain Tube, Route to building drain
Back View, Drain Pump Model
June 2008
Page 10
