Figure 2
Figure 3
IMPORTANT INFORMATION FOR RECHARGING HOT BATTERIES
When using your cordless angle drill/driver con- tinuously, the batteries in your battery pack will become hot. You should let a hot battery pack FRRO GRZQ IRU DSSUR[LPDWHO\ PLQXWHV EHIRUH attempting to recharge. When the battery pack becomes discharged and is hot, the red light on WKHFKDUJHUZLOOÀDVK:KHQWKHEDWWHU\SDFNFRROV down, the red light will glow continuously to indi- cate fast charging mode,
NOTE. This will occur when continuous use of your tool causes the battery pack to become hot. It does not occur under normal conditions.
VII - Know your product
212))VZLWFK
)RUZDUGUHYHUVHVZLWFK
3.Keyless chuck
4.Torque control collar
5.Battery
6.Charger
/('FKDUJHLQGLFDWRU
8.Spindle lock button
VIII - Operation
SWITCH OPERATION
1.When the trigger switch is depressed, the tool rotates. When the trigger is released, the tool
VWRSV Fig. 4
2.The rotation speed can be controlled by varying
WKHSUHVVXUHRQWKHWULJJHUVZLWFK/LJKWSUHV- sure on the trigger switch results in low rota- tion speed, further pressing results in smooth increase of the rpm to maximum upon reaching the extreme position.
Figure 4
INSTALLING AND REMOVING BITS
CAUTION: Switch off the power tool prior to any procedure on it. To avoid involuntary switching on we recommend removing the battery pack.
3UHVVEXWWRQ WRORFNWKHVSLQGOH
5RWDWHWKHFKXFN FROODUDQWLFORFNZLVHXQWLO WKHMDZVRSHQVXIILFLHQWO\IRUWKHELWWREHLQ- serted.
3.Rotate the chuck collar clockwise to fasten the chuck.
4.Ensure the bit is secured.
5HOHDVHEXWWRQ
7RUHPRYHWKHELWZLWKEXWWRQ GHSUHVVHGURWDWH the chuck
CAUTION: 1HYHU SUHVV EXWWRQ while the spindle is still rotating. Otherwise this shall damage the tool and invalidate the manufacturer’s warranty.
TIGHTENING AND LOOSENING SCREWS
Install the bit that matches the screw, line up the bit in the grooves of the head of the screw then tighten it.
|
|
| Instruction Manual | 7 |
| EN |
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
|
| 17.3.2006 . | 09:11:20 |
| ||
|
|
|
|
|
|
|
|
