16.PlaceRIPFENCE on table ...
CAREFULLY | move it against | blade | so that it is | parallel | |||
to the blade, and just TOUCHES tips of saw teeth ... | |||||||
tighten RIP FENCE LOCK KNOB HANDLE. |
| ||||||
17. Insert | folded | paper | between | SPREADER | and | ||
FENCE... |
| hold | spreader | flat | against fence.., | tighten | |
screws | using | 7/16 in. wrench, Now tighten Hex Hd. | |||||
Screws | in Support. |
|
|
|
|
| |
18. To remove | BLADE | GUARD | AND | SPREADER, | loosen | ||
THUMBSCREW.,. |
| DO | NOT | LOOSEN | OTHER | ||
SC R EWS. |
|
|
|
|
|
| |
FOLDED PAPER
7/'16 IN. WRENCH
MOUNTING THE MOTOR
NOTE: Motor is included with Model 113.298031 and
113.2981 51.
CHECK MOTOR ROTATION
1.The motor must rotate CLOCKWISE when viewed from the 5/8 in. shaft.
2.MAKE 'SURE "KEY" IS REMOVED FROM SHAFT.
3.Place the motor on your we rkbench or on the floor.
4, Plug the cord into a properly grounded outlet (See
"Motor Specifications and Electrical Requirements"
Section) Notice the rotation of the shaft, If t is not
turning CLOCKWISE, REMOVE the plug from the outlet, and change the rotation of the motor according to the instructions furnished with the motor,
KEY
/
5/8 IN.
DIA. SHAFT
WARNING: FOR YOUR OWN SAFETY, MAKE SURE PLUG IS NOT CONNECTED TO POWER SOURCE
OUTLET WHEN CHANGING MOTOR ROTATION.
5. From among the loose parts, find the following hardware:
4 Carriage Bolts, 5/16 - 18 x 3/4 in. long 4 Hex, Nuts, 5/16- 18
(approx. dia. of hole 5/16 in.)
4 Lockwashers, 5/16 in. External Type (approx. dia. of hole 5/16 in,)
6.Remove Blade Guard and Spreader.
7.Place motor on MOTOR BASE ... insert bolts through
holes in base ... then through the motor. Install Iockwashers, and nuts.
B. Position motor so that edge of MOTOR FOOT and MOTOR BASE are even ... slide motor all the way to the RIGHT ... tighten the four nuts.
9, Loosen set screw in motor pulley using 6/32 in. setscrew wrench. Slide pulley on shaft with HUB away
from motor. DO NOT TIGHTEN SETSCREW,
10.Install 3/16 in. square key (furnished with motor) in grooves in pulley and motor shaft, DO NOT TIGHTEN SETSCREW.
LOCKWASHER | THESE I"VVO | CARRIAGE BOLT |
5/16 IN. | EDGES EVEN |
NUT !
SHAF- | _4.(_ t i /" |
GUARD
\/
(/.
MOTOR BASE
MOTOR MOUNTING
BASE
PULLEY
KEY
16
