When "WIDTH OF RIP" is 2 in. to 6 in, wide USE THE

PUSH STICK to feed the work.

When WIDTH OF RIP is NARROWER than 2 in., the push

stick CANNOT be used because the guard will interfere. _.

USE the AUXILIARY FENCE_WORK SUPPORT and

PUSH BLOCK.

Attach Auxiliary Fence/Work Support to rip fence with two "'C'" clamps.

Feed the workpiece by qand along the AUXILIARY FENCE unti the end is approx. 1 in. past the front edge of the table. Continue to feed using the PUSH BLOCK.

Hold the workplece in position and install the PUSH

BLOCK by sliding it on top of the AUXILIARY

FENCE;WORK SUPPORT (This May Raise Guard).

3AFFLE

Narrow stri#s thicker than the Auxiliary Fence/Work

Support may enter the guard and strike the baffle.

CAREFULLY raise guard only enough to clear the

workpiece. Use PUSH BLOCK to complete cut.

PLOUGHING AND MOLDING

PLOUGHING is grooving with the grain the long way of the

workDiece, using the fence. USE proper holddowns and feed devices.

MOLDING is shaping the workpiece with the grain tne long

way of the workpiece, using the fence. Use proper holddowns and feed devices.

2?'

Page 27
Image 27
Sears 113.298141 owner manual Ploughing and Molding, Push Block