4.
To remove insert.
A) LoosenScrew
B) Lift insert from front end, and pull toward front of
saw,
To replace insert.
Place insert into insert opening in table and push
toward rear of saw to engage spring clip and until
keyslot in insert will drop over screw. Tighten screw.
Do not tighten screw to the point where it will deflect
the insert.
CHECKING BLADE SQUARENESS TO TABLE
IMPORTANT: BLADE must be SQUARE (g0°) to TABLE,
inorder to proceed with assembly.
To check for blade squareness,refer to "BLADE TILT, OR
SQUARENESS OF BLADE TO TABLE" adjustment on
page 30.
CHECKING BLADE FOR HEEL
IMPORTANT: Saw blade MUST beparallel to miter gauge
groove,
To check for parallelism, refer to "HEELING
ADJUSTMENT OR PARALLELISM OF SAWBLADE TO
MITER GAUGE GROOVE" adjustment on page29 and 30.
ASSEMBLING STEEL LEGS
NOTE: Steel Legs are furnished with Model113.298031
and 113,298151. From among the loose parts, find the
following Hardware:
24 Truss Head Screws, 1/4 - 20 X 5/8 in. long (top of
screwis rounded)
24 Lockwashers, 1/4 in. External Type (approx. dia, of
hole 1/4 in.)
24 Hex Nuts, 1/4 - 20 (approx. dia. ofhole 1/4 in.)
8 Hex Nuts, 1/2 - 13 (approx. dia. of hole 1/2 in.)
4 Leveling feet.
Assemblethe legsasshown .,.
1. Insert the Truss Head Screwsthrough the holes in the
legs, then through the holes in the stiffeners. MAKE
SURE THE SCREWS GO THROUGH THE HOLES IN
THE SIDE STIFFENERS MARKED "×".
2. Install the Iockwashers ... screw on the nuts but do
not tighten until completely assembled.
3. Install leveling feet.
END
STIFFENER"
SIDE STIFFENER
IN. HEX NUTS
_LEVELING FOOT